Does anyone sell 3.5mm TRS to dual 3.5mm TS y cables?

esotericmetal · Post by **esotericmetal** » Wed Aug 30, 2017 9:32 am

The only ones i've seen have dual 1/4" ts connectors. I'm thinking I may just have to buy one of them and solder my own connectors on.

I need them to connect my qunexus cv outs to eurorack which uses two 3.5mm trs jacks to output 4 cv signals. Seems like the only off the shelf options are the cv connection kit from KMI, which i'm not interested in as it comes with cables i don't need/already have and is kinda overpriced in general.

flashheart · Post by **flashheart** » Wed Aug 30, 2017 9:35 am

Seen splitters on Ebay, not seen cables like that though.

DMR · Post by **DMR** » Wed Aug 30, 2017 10:53 am

How about https://www.amazon.com/Hosa-YMM-261-Ste ... 000068O5H/ ?

chysn · Post by **chysn** » Wed Aug 30, 2017 10:56 am

I faced the same issue when I got a QuNexus. I looked everywhere for ones like the KMI kit has, without luck. I bought two of of the Hosa YMM-261 breakout cables referenced above ^^^ and then I just finish it off with regular Eurorack patch cables. That does the trick, and it isn't thirty $$$ bucks, and you can use any patch cables you have lying about.

erstlaub · Post by **erstlaub** » Wed Aug 30, 2017 11:24 am

I've had a few solutions over the years for my BSP to Pam's sync cable but none off the shelf.

I had a spare TRRS AV cable lying around from a media player or projector or something, using a scope or a meter I discovered which 2 of the 3 phono jacks gave me run and clock signals and just used phono to 3.5mm jack adapters for a bit.

I ended up with a TRS cable with no end on it so soldered a couple of 1/4" jack sockets to it and mounted it all in a little case that I used with 1/4" to 3.5mm adapters plugged in.

I more recently found a few spare 3.5mm jacks and cut out the faffing around and soldered them right to the cable instead of via the sockets. It's much tidier and easier to use.

joem · Post by **joem** » Wed Aug 30, 2017 4:16 pm

When I needed one a few months ago, I went with the Hosa adapter mentioned above. Works fine.

jsco · Post by **jsco** » Wed Aug 30, 2017 7:34 pm

DMR wrote:How about https://www.amazon.com/Hosa-YMM-261-Ste ... 000068O5H/ ?

thanks, you reminded me that i needed to order a pair of these! (for patching into the stereo input channels on panmix.)

the elektron audio/cv split cable kit works for this job if you have one, but it's like five times the cost.

shamann · Post by **shamann** » Wed Aug 30, 2017 8:33 pm

More expensive than the Hosa splitter, but there's also these:

https://www.harpooncables.com/blank-rwr ... ts-y-cable

macs4music · Post by **macs4music** » Thu Aug 31, 2017 3:32 am

Maplin here in the U.K. Do them; I think you have Radio Shack over the water?

Neil

macs4music · Post by **macs4music** » Thu Aug 31, 2017 3:39 am

Here's the maplin link if anyone needs it:

https://www.maplin.co.uk/p/maplin-35mm- ... pter-a71xc

I use two of them with my Qunexus and they work really well.

Neil

kay_k · Post by **kay_k** » Thu Aug 31, 2017 4:19 am

I had the same stupid problem when using the din-sync out of the Arturia Beatstep Pro to clock Pamela's Workout and Metroplis.
I use something like this now with standard RCA-3.5mmTRS-cables:
http://www.ebay.de/itm/2x-Cinch-Klinke- ... SwOVpXZZWK

I also use this to mult it before I split it:
http://www.ebay.de/itm/Hub-Splitter-Ste ... SwHJhXNBnP

MUFF WIGGLER

MUFF WIGGLER

Does anyone sell 3.5mm TRS to dual 3.5mm TS y cables?

Does anyone sell 3.5mm TRS to dual 3.5mm TS y cables?