Unkle SQR ----> Envelator not usually work???

Kendall Station · Post by **Kendall Station** » Fri Jan 06, 2012 7:54 am

I've two unkles, and two envelators. for some reason the Unkle Square out won't trigger the envelator in AD or Cycle mode. Works fine in AR mode. Sawtooth out DOES trigger AD mode.

Ive tried with both Unkles and both Envelators. Is something wrong or is this just the way it is?

PS - CLK out form NR also works.

Thanks!

bsmith · Post by **bsmith** » Fri Jan 06, 2012 8:09 am

The rise part of the unkle sqr duty cycle doesn't look like it gets quite high enough for my envelators AD - saw is doing the deal though.

fester · Post by **fester** » Fri Jan 06, 2012 9:39 am

any comparator with standard unipolar 10V output will translate this trigger threshold issue.

fac · Post by **fac** » Fri Jan 06, 2012 10:15 am

AFAIK, envelators cannot be retriggered in cycle mode.

bsmith · Post by **bsmith** » Fri Jan 06, 2012 10:22 am

They can be retriggered in cycle mode.

Kendall Station · Post by **Kendall Station** » Fri Jan 06, 2012 2:22 pm

They retrigger in cycle mode, yes they do

.

The reason this all seems odd to me is that I believe the envelator's gate input threshold is about 2v, which should be nabbed by the sqr out.

reignbear · Post by **reignbear** » Fri Jan 06, 2012 2:36 pm

I had a similar observation when i had my uncle trying to trigger my maths...I would use something else to boost the signal a bit, but it was kind of a nuisance.

Hi5 · Post by **Hi5** » Fri Jan 06, 2012 2:42 pm

I'm sure it has something to do with your PSU in some way.

Kendall Station · Post by **Kendall Station** » Fri Jan 06, 2012 3:39 pm

Hmm tta uzeus.

certainly anamolous phenomenon.....not the end of the world tho

MUFF WIGGLER

MUFF WIGGLER

Unkle SQR ----> Envelator not usually work???

Unkle SQR ----> Envelator not usually work???